Info: UUIDs and ID's in use in the XVPAdmin interface do not map to UUIDs from the User or Admin User Interfaces as they are separate systems.
This tab shows all the networks that are currently configured in the platform. These pages are only ever really used when debugging potential problems on the platform or with a VLAN and normally housekeeping work would be done through the Administration or User Control Panel.
Firstly you need to select the Cluster you wish to look at. Once you have done that the following fields are displayed:
- Network ID
- Network Name
- VDC ID
- VLAN ID
- IPv4 Subnets
- IPv6 Subnet Active
Selecting a network will bring up further informatio on that network:
Network Details
When a network is selected the following information is displayed:
- Network ID
- Network Name
- Cluster ID
- VDC ID
- VLAN ID
- Traffic In Counter
- Traffic Out Counter
IPv4 Subnets
The IPv4 subnets tab shows the following information about any subnets in use by that network:
- Cluster ID
- Subnet ID
- VLAN ID
- Broadcast Address
- Gateway Address
- Network Address
- Mask
- Start IP
IPv6 Subnet
The IPv6 subnet tab shows the following information about an IPv6 subnet if in use by the network
- Cluster ID
- Mask
- Network Prefix
- Router Address
- Router Enabled
- Subnet ID
- VLAN ID
Flexiant Cloud Orchestrator only supports one IPv6 subnet per VLAN as there is no need to support more than one due to the size of a typical IPv6 subnet
IP Addresses
If using Public Virtual IP mode, then IP addresses will be listed under this tab.